Author Topic: Victory revs after top-end refresh  (Read 148 times)

0 Members and 1 Guest are viewing this topic.

Offline Mountainsofbeer

  • Forum member
  • Back Lane Scratcher
  • Posts: 108
  • Location: New England
Victory revs after top-end refresh
« on: September 17, 2022, 08:45:27 PM »
Video of running after first ride this weekend.I had a base gasket leak and refreshed the top-end and cleaned carbon from ports and heads etc.
I honed it with a drill attachment and it measured 43.04 or 43.05 but I don't have equipment for oversize yet. I did use new 307 rings and one new piston because I also found a stuck ring on the left hand side and couldn't properly clean it too much varnish and looked bad.  Overall it was a success

https://youtu.be/F9TBOhyGGzM
« Last Edit: September 17, 2022, 08:48:02 PM by Mountainsofbeer »

Offline Gr8uncleal

  • Club Member
  • Port Hacker
  • Posts: 3203
Re: Victory revs after top-end refresh
« Reply #1 on: September 18, 2022, 07:50:36 AM »
Sounds good.  ;)

A shame the bikes your side of the pond came without tachos. Maybe that could be your next upgrade...... :P
Yam RD200DX
Yam FZX700 Fazer
Yam RD400C
Yam RD350B
Yam RD350
Yam RT2
Yam DT360A
Suzi GT550J
Suzi 1250 Bandit
Yam RD125A
Yam R5
Yam DT3
Yam CT1C
Yam RD200B

Offline Mountainsofbeer

  • Forum member
  • Back Lane Scratcher
  • Posts: 108
  • Location: New England
Re: Victory revs after top-end refresh
« Reply #2 on: September 18, 2022, 10:49:24 AM »
Sounds good.  ;)

A shame the bikes your side of the pond came without tachos. Maybe that could be your next upgrade...... :P

Yes and a steering dampner as well, I'll always be alittle jealous of the other models heh.   I plan on buying an RD200 as soon as I can afford it and I think they kept the tach on those models.