AIRCOOLEDRDCLUB FORUM

Tech Zone => Aircooled RD Tech Help 250cc and Above => Topic started by: Brumloz on December 04, 2018, 07:35:12 AM

Title: YR5 engine rebuild
Post by: Brumloz on December 04, 2018, 07:35:12 AM
Just starting my R5 engine rebuild and was after the correct torque for the clutch centre nut and the crank primary gear nut, Can not see much mention in the manual I have. Any help appreciated.   :)
Title: Re: YR5 engine rebuild
Post by: splant on December 07, 2018, 09:27:00 AM
I'd think 35lbs ft would be about right ,certainly enough anyhow.
Title: Re: YR5 engine rebuild
Post by: AndyDean42 on December 07, 2018, 10:52:22 AM
The 400C manual which is basically the same as any RD stated 36-58ftlbs.

Andy